General test equipment discussion
Page 2 of 2 • 1, 2
Re: General test equipment discussion
^^^ Looks like my homebrew RF probe or DMM is 2.1 mV off...Can't be the Tek. 

Ragwire- Member
- Number of posts : 510
Registration date : 2013-05-20
Re: General test equipment discussion
Nice looking unit! I've seen them on the market for a long while, so they must be a refined product.
75X11- Member
- Number of posts : 4453
Age : 64
Registration date : 2013-03-10
Re: General test equipment discussion
It's been a joy to use. Did my old Heathkit do the job? You bet it did! (And still does...it is a backup unit now) But the new one is more accurate on the dial settings...mostly at the higher frequencies like FM, VHF. And the output is a fair bit stronger when turned all the way up.
Ragwire- Member
- Number of posts : 510
Registration date : 2013-05-20
Re: General test equipment discussion
One thing that may help the output signal is to use a 50ohm termination with a T-BNC. Then use the open none used end for the Scope or counter probe. Most low end generators have impedance that are not standardized.
Then you would get reliable scope or counter measurements.
Another thing you could do is make a chart with the main frequencies marked every 10 squares. Using Engineering paper.
Then hook up and measure with Scope or frequency counter and mark the vertical lines with the frequencies for the analog dial position. Then on the bottom Horizontal frequency numbers Using the same numbers as the vertical lines, mark the frequency counter numbers.
This would help you see how far off the generator is at specific frequencies. Remember though some times the generator will overload the counter and you will see a harmonic frequencies over the primary frequency. That's where a termination will help, as it will act as a load. Have I explained it correctly?
Mark both frequencies and draw a line between each of the frequencies on your chart to get an Idea of how accurate the generator dial is.
Then you would get reliable scope or counter measurements.
Another thing you could do is make a chart with the main frequencies marked every 10 squares. Using Engineering paper.
Then hook up and measure with Scope or frequency counter and mark the vertical lines with the frequencies for the analog dial position. Then on the bottom Horizontal frequency numbers Using the same numbers as the vertical lines, mark the frequency counter numbers.
This would help you see how far off the generator is at specific frequencies. Remember though some times the generator will overload the counter and you will see a harmonic frequencies over the primary frequency. That's where a termination will help, as it will act as a load. Have I explained it correctly?

Mark both frequencies and draw a line between each of the frequencies on your chart to get an Idea of how accurate the generator dial is.
Resistance is Futile- Member
- Number of posts : 913
Registration date : 2008-03-12
Page 2 of 2 • 1, 2
Permissions in this forum:
You cannot reply to topics in this forum
|
|